Center Bolt to Use with Equalizer # 13-108-3
Updated 10/28/2020 | Published 10/27/2020
Products Featured in This Question
Question:
In the diagram for part # 13-108-3 what bolt would you put in the D spot? Also where the spring slides in on this new one is different than the one being taken off. Will the old springs work with this unit? The old unit had a metal cylinder/tube welded for the spring to sit on instead of a metal plate shown in the new one.
asked by: Noah C
0
Expert Reply:
You'd want to use a center bolt like part # TRFA71063 in the center hole of equalizer part # 13-108-3. Your current springs should still work just fine as it would just rest on the plate.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Dexter Equalizer for 3" Wide Slipper Springs - 18-3/8" Long - 1-1/8" Center Hole
- Trailer Suspension Parts
- Standard Equalizer
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 3 Inch
- 18-3/8 Inch Long
- Tandem Axle
- Triple Axle
- Dexter
more information >
Continue Researching
- Q&A: Tonneau Covers that Fit 2021 GMC AT4 with 5-3/4 foot Carbon Pro Bed
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Inner Member for TDE LP8500 Actuator
- Q&A: Which TruXedo Elevate Truck Bed Rack System Fits 2024 GMC Sierra 1500 & Soft Tonneau Cover
- Q&A: Replacement Oil Seal for LCI 295924
- Q&A: Replacement Bushing for Dexter 3 Equalizer # 13-108-3
- Q&A: What is the Capacity of a Dexter P-12 Model D100 Axle
- Article: Slipper Spring Trailer Suspension System Review
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Article: Trailer Hitch Installation Tips
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Most Popular Wheel Bearings