Searching For Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System

Question

Question:

Part number on 6 pt level control doesnt match the part# that comes up

asked by: Jeanne

0

Expert Reply:

Our Part # LC675817 is the 6-point Lippert Ground Control 3.0 System. Lippert uses 675817 which is the exact same system we carry except we add the "LC" to the part number.

expert reply by: Adam E

0

Answer 1

The middle and rear jack mounting brackets of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 that you referenced are a total of 6 inches in width. That's how much free room…

view full answer...

Answer 2

Yes having the rear jacks of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC675817 24 inches from the rear axle would be totally fine.

view full answer...

Answer 3

The mounting brackets for the rear legs of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC675817 are designed for I-Beam frames but I had mentioned before that others will a box frame have had the system…

view full answer...

Answer 4

Yes, the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote #LC675817 which uses 6 points for leveling would fit and work well on your 2010 Keystone Montana fifth wheel. This would be an excellent way to keep your…

view full answer...

Answer 5

I don't know what type of brackets were used on your 2022 Heartland RV Torque 5th Wheel but we carry the #LC349975, which can really only be installed at one height since they have lip that butts up against the bottom of the I-Beam. If clearance…

view full answer...

Answer 6

I sent your picture to my tech contact at Lippert and they responded with saying that the mounting brackets are designed to go behind and under the cross shaft of the slide out. If you check out the picture I attached you'll see how it would fit…

view full answer...

Answer 7

Yes, the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 will fit and work great on your 2017 Forest River Hemisphere 372RD. Having slide outs near the wheels is a very common setup on RVs so that would not be an issue. I…

view full answer...

Answer 8

We've had this question before and when I spoke to Lippert about this scenario they responded with saying that the mounting brackets are designed to go behind and under the cross shaft of the slide out. If you check out the picture I attached…

view full answer...

Answer 9

No, I am sorry it will not Rich. The Replacement I-Beam Jack Bracket for Lippert Ground Control 3.0 item #LC349975 only works with the Lippert Ground Control 3.0 item #LC675817 and the item #LC358590 systems. We do not have a replacement bracket for…

view full answer...

Answer 10

We've spoken with Lippert in the past about alternate mounting locations for the rear jacks if there is anything that would interfere with the recommended dimension. Here's what they told us as far as where you can mount the jacks on the…

view full answer...

Answer 11

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad and Remote - 6-Point Set #LC675817 has been the manufacturers choice for a long time and the system I recommend for your 2017 Forest River Blue Ridge Cabin Edition. It is…

view full answer...

Answer 12

Yes, you can install the rear jacks on the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System part #LC675817 so that there is more than 7" of ground clearance. That said, any additional ground clearance added to the jack location…

view full answer...

Searching For Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching