Parts Needed To Install Curt Brake Controller On a 2018 Ford E-Series Cutaway
Updated 07/14/2020 | Published 07/10/2020
Products Featured in This Question
Question:
My Ford has the factory 7 wire plug. It also has the factory plug behind the dash panel. I have a new Curt Discovery controller from another vehicle. I have ordered the 3034 adapter. The plug was cut from the Discovery when installed. Is there any reason I cannot hardwire the adapter to the controller? I appreciate the help.
asked by: Mike B
0
Expert Reply:
Product Page this Question was Asked From
Curt Discovery NEXT Trailer Brake Controller - Up to 4 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LCD Display
- Single Trailer Only
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Parts Needed to Flat Tow 2025 GMC Canyon
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Q&A: How Long Does It Take To Install Air Force One Supplemental Braking System
- Q&A: Brake Stoplamp Switch Wire Color For Brake Controller Install on 2016 Ford F150
- Q&A: Grease Seal Recommendation to Replace AD2527E
- Q&A: Trailer Hitch for 2024 BMW X5 50e
- Article: Trailer Lighting Requirements
- Q&A: How Thick Are Electric Brake Shoe Pads and When Should They be Replaced
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: The Best Towing Mirrors