Brainstorming Sidewind Trailer Jack for 2 Inch Receivers On Cargo Trailer Corners For Stabilization

Updated 05/21/2020 | Published 05/19/2020

Products Featured in This Question

Scissor Stabilizer Jack - 18-3/4" Travel - 2,500 lbs - Qty 1

(791)

$59.85

Curt Solid Steel 2" Hitch Bar with Raw Finish - 12" Long

(170)

$47.94

Combo Bar 6" with 2" Trailer Hitch Receiver - Unpainted

(416)

$24.77

etrailer Boat Trailer Jack w/ Footplate - Sidewind - Fixed Mount - 29-1/8" Lift - Zinc - 2.5K

(1029)

$149.70

Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-3/4" Lift - 3,000 lbs

(245)

$87.82

Replacement Manual Crank Handle for Ram Scissor Stabilizer Jacks - 5,000 lbs

(45)

$31.81

Question:

looking for a side wind trailer jack that will mount directly into a 2 receiver? My cargo trailer has a 2 receiver at each corner to stabilize it during use.

asked by: Will C

Helpful Expert Reply:

Interesting. We don't have that specifically, but there are a couple of routes you could go. Most trailers will use the Scissor Stabilizer Jack - 18-3/4" Travel - 2,500 lbs - Qty 1 # TJSC-24 for stability in the corners so you could mount a receiver shank to that and use # TJSC-24-HD as a sidewind crank.

It sounds like you were picturing more of a trailer tongue style option, so you could use a jack like the etrailer Square Jack w/ Footplate - Drop Leg - Bolt On - Zinc - Sidewind - 29-1/8" Lift - 2.5K # MJSQ-2500B for a bolt on option or the # TJD-5000S for a weld on option mounted to a receiver shank like # D30 to fit a receiver like # E-9.