Does Yakima Holdup 2 Bike Hitch Add On Fit Older Version of Yakima Holdup

Question

Question:

On July 2010, I purchased the Yakima Holdup 2 #02433. The spine color is grey. I now wish to purchase the add-on to increase my Holdup’s capacity from 2 to 4 bikes. Is model number Y02446 the correct Holdup+2 model to fit my 2010 Yakima Holdup?

asked by: Ruben

1

Helpful Expert Reply:

Yes, I confirmed with Yakima that the expansion kit part # Y02446 does fit your earlier version of the Holdup # 02433.

expert reply by: Jameson C

1

Answer 1

Between the Yakima HoldUp 2, part #Y02443 and the Sherpa 2.0, part #SH22G, I personally like both, however, they are built around different bikes and uses. The Yakima HoldUp is a better rack if you have kids bikes, heavier bikes, or could possibly…

view full answer...

Answer 2

The Replacement Hitch Bolt #Y8890200 is the correct bolt for your Yakima HoldUp Bike Rack #Y02443. We also have the Replacement Hitch Hardware #8890260 if you need to replace the insert inside the Spine #8890277.

view full answer...

Answer 3

To replace the threaded hitch pin and lock for your Yakima HoldUp, it will depend on if you have the 2" shank or if you have the 1-1/4" shank with a 2" adapter. For the 2" shank, you will need the Replacement Hitch Bolt and Clip…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 9

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 10

From what I can find the Norcold N306.3 fridge has a 2.7 cu ft capacity and is 20-1/8" wide and 26" tall. The most similar option we can offer is the 3.2 cu ft Everchill RV Mini Refrigerator #324-000111. The #324-000111 measures…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Does Yakima Holdup 2 Bike Hitch Add On Fit Older Version of Yakima Holdup

Continue Researching