Length of Mounting Hardware for Rack'em Fitz-All Enclosed Trailer Ladder Rack

Question

Question:

How long are the mounting screws that fasten the rackem roof racks to the trailers, my trailer is finished inside and i dont want them to protrude through the wall

asked by: James

0

Expert Reply:

The screws that mount the Rack'em Fitz-All Enclosed Trailer Ladder Rack # RA-28 are 2-1/4" long. They need to be this long in order to ensure the screws are able to go through the frame and body of different sized enclosed trailers.

I have added links to a video install as well as a video review for you to check out of the Rack'em Fitz-All Enclosed Trailer Ladder Rack # RA-28.

expert reply by: Kyle S

0

Answer 1

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 2

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 3

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 4

Hey Ben, for enclosed trailers like your 2020 Car Mate enclosed trailer the best option for a roof rack would be the Rhino Rack Aero Bar roof rack for camper shells part #Y02-480B since you plan to put kayaks and a cargo carrier up there. We have…

view full answer...

Answer 5

Since your 2020 Jeep Wrangler Unlimited does't have a tow package, there are a few parts you'll need to install before you can use a brake controller, but I can recommend ones that will require little to no splicing, to make the install as…

view full answer...

Answer 6

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 7

Yes, we do have a roof rack that will work with the rounded roof on your Interstate cargo trailer. It is the Rack'Em Fitz-All Enclosed Trailer Ladder Rack item #RA-28. This roof rack has a 400 lbs capacity and mounts to the side of your trailer…

view full answer...

Answer 8

Hey Adina, from what I could find the Norcold N811F requires a cutout that is 60" high x 23-1/2" wide x 24" deep. I would double check your opening just to be sure but based on those dimensions I recommend the Norcold RV Refrigerator…

view full answer...

Answer 9

Hey Jon, yes you sure can! And it's not too difficult either. If your vehicle already has a 4 way flat on the back, you can just install the #ETBC7 which converts it to a 7 way to be used with trailers that have electric brakes. Basically the 4…

view full answer...

Answer 10

I'd have to see the roof so that I could send it to our roof rack manufacturers to see what would be the best.

view full answer...

Length of Mounting Hardware for Rack'em Fitz-All Enclosed Trailer Ladder Rack

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching