Replacement Landing Gear Legs for Montana RV Fifth Wheel
Updated 04/06/2020 | Published 04/05/2020
Products Featured in This Question
Question:
I have a 2006 Montana 3400RL 5th wheel. The landing gear came with pull pins to adjust the length of the landing gear. One of my pull pins just broke the cylinder where the spring is broke loose where it is welded to the clamp on bracket. I am trying to pick the correct replacement. The leg is 2 1/2” square and the pin is 3/8” diameter. What is the correct part number? I want to get a set of two.
asked by: Dennis L
Expert Reply:
Keystone had special landing gear made for their Montana RVs so for replacement legs you'd want the part # LC178653 for the driver leg or part # LC178652 for the replacement follow leg.
Product Page this Question was Asked From
Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Continue Researching
- Shop: Replacement Lead Leg for Keystone Montana 5th Wheel Landing Gear
- Shop: Replacement Follow Leg for Keystone Montana 5th Wheel Landing Gear
- Q&A: Landing Gear Replacement for 2011 Keystone Montana
- Q&A: Replacement Landing Gear for 2006 34 ft Keystone Montana
- Q&A: Replacement Landing Gear for Frame Clamps That Measure 18-1/2 Inches Apart
- Q&A: Replacement Legs for Lippert Components Ground Control 3.0 Electric Leveling System
- Q&A: Determining The Correct Replacement Landing Gear For A 2010 Keystone Montana
- Q&A: Replacement Landing Gear Legs for a Nu Wa Hitchhiker 5th Wheel Trailer
- Q&A: Tandem Landing Gear Recommendations For Thor Vortex Toy Hauler RV
- Article: What Do I Need To Tow A Trailer?
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps