What is the Angle of the Handle on the A-Frame Trailer Jack DL22530
Published 04/03/2020
Question:
A bracket. I have attached the query in the attachment, please respond to it. We are looking for 2 of the lift jack of this type.
asked by: Sanjay S
0
Expert Reply:
In regards to the A-Frame Trailer Jack part # DL22530, the handle sits at a 90 degree angle in relation to the rear two mounting holes. The distance between the inside of the handle and the outer tube of the jack is 1-1/8". I have filled these figures in for you using the photo you sent.
expert reply by:
Conner L
0
click to enlarge
Product Page this Question was Asked From
Dutton-Lainson A-Frame Trailer Jack - Sidewind - 15" Lift - 1,000 lbs
- Trailer Jack
- Utility Trailer
- A-Frame Jacks
- Sidewind Jack
- 0 - 1000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Would Lift Kit for 2006 Jayco Pop Up Allow for Off Road Tires
- Q&A: 2 inch Outer Diameter A-Frame Trailer Jack Recommendation
- Q&A: Availability of Trailer Jack with Outer Tube Diameter of 2 inches
- Q&A: Replacement Crank for Atwood Electric Trailer Jack
- Q&A: Availability of Atwood 75029 Bevel Gear/Bearing Kit
- Q&A: Replacement Jack Recommendation for Fulton F2 Marine Jack
- Q&A: Replacement A-Frame Jack With 2 Inch Outer Tube
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Testing Breakaway Systems
- Article: Best Bike Racks for Electric Bikes
- Article: Can You Flat Tow a 2024 Chevy Blazer?
- Article: How to Replace an RV Roof Vent Cover