Is Drive Nut Replaceable on 2,000 lb A-Frame Trailer Tongue Jack

Updated 03/30/2020 | Published 03/28/2020

Products Featured in This Question

Bulldog Round, A-Frame Jack - Topwind - 15" Lift - 2,000 lbs

(516)

$64.25

Replacement Square Footplate for Bulldog Round Trailer Jacks w/2" Diameter Tubes - 2" Tall

(312)

$20.74

Question:

Doesnt someone sell the 1 7/8 round drive nut ,3/4 inch diam. threaded center- to replace the stripped out one on top of inner pipe on these jacks. They are stamped into top of inner pipe, but easy to remove. I need a new one. Here is pic of drive nut -round 1 +3/4 to 1 7/8 diam.,and 3/4 inch diam flat thread screw drive center. No part number or name on it.I believe it is Fulton or same as your new ones? Thanks

asked by: Jim W

Helpful Expert Reply:

I did some digging but unfortunately it doesn't look like that nut is replaceable all on its own. I think that is typically changed out with the screw but even then I wasn't able to find anything for a 2K Fulton jack. When I reached out to my contact at Fulton he said that it's actually cheaper to replace the entire jack than it is to replace that screw nut anyways so he recommended just replacing it instead.

For a replacement jack I recommend the Bulldog Round, A-Frame Jack # BD155033 because of how easy it is to use and how reliable Bulldog jacks are. This jack has a 2K weight rating and a 2-1/4" out/2" inner tube design. While the tubes are a little bigger than what you currently have, the mounting hole pattern should still match up just fine which is 3" apart on center. I recommend using the footplate # BD018564 with this jack.

Attached is a review video for you to check out.

expert reply by: Jon G