What Normally Seals RV Sewer Pipes
Updated 03/23/2020 | Published 03/22/2020
Products Featured in This Question
Question:
I need to cut off these bottom black tank fittings and Not sure how to do it to get a good seal and fitting when putting back together. Do you have any suggestions?
asked by: Chris D
0
Expert Reply:
When replacing RV sewer lines you have to cut them totally off since the ABS cement is a permanent plastic weld. Then when you go to make new connections you end up having to replace anything that can't be separated. Or you can use adapters to fit into or over the old pipes and use solvent to make the connection.
For solvent we have the part # 3447530889.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Valterra Eccentric Tank Reducer - RV Gray Water - 3" Spigot to 1-1/2" Hub
- RV Sewer Hose Fittings
- Sewer Adapters
- Sewer Couplers and Nipples
- Reducer Couplers
- Hub
- Spigot
- Sewer Pipe to Sewer Outlet
- 1-1/2 Inch Diameter
- 3 Inch Diameter
- Valterra
more information >
Continue Researching
- Q&A: Removing and Installing Valterra Eccentric Tank Reducer # T1041-1
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Sumo Springs Versus Shocks for Toy Hauler
- Q&A: What Kind of Sealant is Used to Install Valterra Eccentric Tank Reducer # T1041-1
- Q&A: 3 inch to 1-1/2 inch Reducer for RV Sewer Piping
- Q&A: What Electric Brakes and Grease Seals do I Need for My 2022 Discovery Rover ET ?
- Article: Ram Trailer Tow Prep Package
- Q&A: What is the Difference Between Valterra EZ Valve Electric Waste Valves # E85-8 and # E84-8
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Can You Flat Tow a 2025 Chevy Trax?
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers