4-Way Round Chrome Car End for a 2003 Jeep Wrangler To Tow Behind Motor Home

Published 07/01/2009

Products Featured in This Question

Pollak Heavy-Duty, 4-Pole, Round Pin Socket, Concealed Terminals - Chrome - Vehicle End

(49)

$12.29

Hook Probe Circuit Tester

(62)

$13.94

Roadmaster 4-Diode Universal Wiring Kit for Towed Vehicles - 4-Way Flat Connectors

(3249)

$100.94

Roadmaster Bulb and Socket Tail Light Wiring Kit for Towed Vehicles - Incandescent

(439)

$83.63

Roadmaster Flexo-Coil 4-Wire Kit

(46)

$72.54

Question:

how do i wire this in a 2003 jeep wrangler tow car? Our mh is wired and has a 4 flat. i have the 4 flat that goes into that with a 4 round on the end that will plug into the 4way to put on. thanks

asked by: Tim

Expert Reply:

To install towing lights on your 2003 Jeep Wrangler you have two options. One way is to use a taillight isolating diode system, RM-154, to wire the motor home lighting system into the cars with diodes protecting both from damage. The second is to use a separate set of bulbs in the rear taillights, RM-155, that are run only from the motor home and do not interact with the vehicle wiring. This option requires enough space in the towed vehicles taillights to mount the extra bulb, but it eliminates any issues with the vehicle warranty. You can install the 4-way round connector on the end of either of these wiring options. you can also use the Roadmaster Flexo-Coil 4 wire kit, RM-164, to span the tow bar distance between the two vehicles. There is no standard for wiring the 4-way round so you will have to use a circuit tester, PTW2993, to test the wires and wire the connector according to the wiring of your existing connector. I have posted links to the parts mentioned above and our wiring help page below.

expert reply by: Robert G