Mounting Hole Dimensions of Dutton Lainson Sidewind Jack # DL22339

Question

Question:

1700 lb trailer jack. what is the spacing of the bolt holes? I already have a welded on plate. thanks

asked by: Gene

0

Expert Reply:

I attached a picture that has the measurements of the mounting holes on the mounting plate of the Dutton Lainson Sidewind jack # DL22339 that you referenced. Basically they are 5-1/2 inches from left to right and then 2-3/8 top to bottom row and then an additional inch for each of the others.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I have attached two diagrams below with the dimensions for the XO350 and XO750. Both of these use a bolt on installation so you really only need to know the height of your tongue to see if it is compatible. The #ORJW350D fits 2" to 6" tall…

view full answer...

Answer 2

The mounting plate on the ARK Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR is 5-1/2" wide and 7-1/2" tall. It is designed with several bolt hole patterns(see image) to fit trailer tongues from 2-6" tall.

view full answer...

Answer 3

The Ark Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels #ORJW750BD you referenced weighs roughly 40lbs. The Ark #ORJW750BD has a 1650lb static weight capacity, and an 1100lb dynamic weight capacity. This jack will offer up to 10" lift and…

view full answer...

Answer 4

With the ARK Xtreme Off-Road Swing-Up Jack #ORJW500D in its lowest position it is 6.49" from the center of the mounting point to the top of the jack. The other end of the jack when fully retracted is going to be 18.89" from the mounting…

view full answer...

Answer 5

The travel of the Swivel Marine Trailer Jack with Caster Wheel part #DL67MR is 10" per the technical drawing from Dutton-Lainson which I have attached below.

view full answer...

Answer 6

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

view full answer...

Answer 7

Since you are not wanting to drill all the way through the aluminum frame on your H and H trailer, you can use U-bolts like #CE15283GA-2 to go around the frame of your trailer, and up into the RC Manufacturing T-Series Trailer Tongue Tool Box -…

view full answer...

Mounting Hole Dimensions of Dutton Lainson Sidewind Jack # DL22339

Product Page this Question was Asked From

Continue Researching