What Gauge and Composition Are the Wires on the LED Combination Trailer Tail Lights by Optronics  

It sure is Barry and welcome back! For a 50' long 30 amp extension, I recommend the Mighty Cord RV Extension Cord w/ Pull Handle item #A10-3050EH. This is a 10 AWG cable with 3-prong male and female plugs. You will see a slight voltage drop of…

Welcome back Kevin. The Dexter DX7.5L A-60 Brake Actuator item #DX33FR with mounting bolts measuring 3" center to center. The holes are 1/2" in diameter and sit 3/4" below where the actuator will sit on top of your coupler. The DX7.5L…

Hello Chris, Thanks so much for writing in and a double thank you for including the full brake assembly part number. That is incredibly helpful! Since you have the Kodiak Disc Brake Kit 11.35" Rotor #120 Spindle 12K ALKO #K2HR12A11-120DW, you…

The KH97202 caliper you have pictured can actually be the left (driver) side or the right (passenger) side. So it wasn't necessarily installed backwards and I found a couple pictures showing that they used to put that casting number on both…

Hey Chris, the Bulldog jack part #BD190758 would do decently in a saltwater environment but honestly it's not going to last forever. The zinc coating and the powdercoat will eventually allow the steel underneath to corrode. Now if you were to be…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

Hello Sean, I do not have a database that shows exactly what components are installed on each individual trailer, but based on my research, you should have a tandem axle setup with each axle rated at 4,400 pounds. You can check the axle tag to…