How to Install a Brake Controller on a 2020 Ford Transit T-250
Products Featured in This Question
Question:
How can I install a brake controller of my 2020 Ford Transit T-250?
asked by: William H
0
Expert Reply:
We have just what you need to get this job taken care of. There are two wiring kits you will need, the Curt T-Connector # C56327 and the Universal Installation Kit # ETBC7. These two kits combined will include everything you need to install a 7-way on your 2020 Ford Transit T-250, including all of the necessary wires for a brake controller. The Tekonsha P3 # 90195 is what we recommend, as it will be an easy 4-wire install.
expert reply by:
Randy B
0

Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Splice-In
- Under-Dash Box
- Under-Dash
- Up to 4 Axles
- LCD Display
- Multiple Trailers
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Brake Controller
- Shop: Gooseneck Hitch
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: D-Shaped Rubber Seal for Enclosed Trailer - Stick On - 25' Long x 3/4" Wide
- Search Results: 56070
- Search Results: etbc7
- Search Results: 90885
- Shop: Dexter Self-Contained Hydraulic Jack- Square Tube - Bolt On - 12,000 lbs
- Shop: Dexter Dual Hydraulic Jack System w/ Double Acting Pump - 12,000 lbs
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: ramp door seal
- Search Results: gcpn~25008
- Q&A: Installing Trailer Brake Controller on 2019 Ford Transit T250
- Video: Comprehensive Review: Dump Door Hinge for Dump Trailers
- Video: Brophy Camper Scissor Steps Review
- Search Results: apubr~1
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Video: Hands-On with the Bearing Buddy Bearing Protectors
- Search Results: a7805
- Q&A: Wiring Diagram for Lippert Replacement Hydraulic Power Unit with 2-Quart Pump Reservoir Kit
- Q&A: Does Dexstar Black Steel Mini Mod 15 x 6 Trailer Wheel AM20560 Have Any Offset
- Video: DIY Install: Curt Trailer Hitch Receiver on your 2008 Land Rover Range Rover Sport
- Shop: Lift Assist
- Shop: Base Plate for Tow Bar
- Q&A: Troubleshooting 10 Amp Fuse Blowing on Lippert Ground Control 3.0 Leveling System
Jim S.
9/8/2020
When I connect the tekonsha p3 brake controller to the cold red stop light wire and use the manual brake the 30a fuse to the positive barely cable burns out. I am trying to connect to a 2020 Ford Transit f150. Is there an alternate wiring diagram. The directions say to wire 1998 -2005 models to the light green wire from thr stoplight switch. Will this work on a 2020?