Will the Pro Series Trailer Hitch Mounted Cargo Carrier Fit a 2008 Acura MDX

Question

Question:

Will the 24x60 cargo carrier work all clearances for a 2008 accura mdx. Would I need the light kit?

asked by: Buddy G

0

Expert Reply:

On the trailer hitches we have installed on a 2008 Acura MDX and similar models, we have found that the distance from the center of the hitch pin hole to clear the rear bumper on the vehicle measures up to 5 inches.

The Pro Series Cargo carrier, # 63153, measures 12-3/4 inches from the center of the hitch pin hole to the nearest edge of the carrier so it will clear the rear bumper. This is also enough distance to allow you to open the rear hatch on the vehicle.

If your tail lights are blocked by the carrier, you will want to use the light kit, but it is just a good idea to use it in general for safety. There are 2 light kit options: # 20174 uses regular bulbs and # 98174LED uses LED bulbs. The LED bulbs draw less power and tend to be brighter. Otherwise they install the same. Take a look at the video I have linked.

To power the lights, you will need a 4-Way wiring harness on the vehicle. If you need one, use # 118424. I have included some links that show how to install the wiring harness for you.

expert reply by: Michael H

0

Rb

12/11/2012

I have a 2008 MDX also. Does the rear hatch open with the eTrailer 20cu ft cargo bag filled? Thanks.

Patrick B.

12/13/2012

On a similar carrier, a 2012 MDX cargo door breaks over the carrier at the 20 inch mark. The 63153 has a bit of a rise to the shank, but it sticks out further than the carrier we measured. Check out the link to the video. The etrailer cargo bag measures 24 inches tall when completely filled, so the cargo door will most likely contact the bag before it is opened all the way.

Helpful Links

tv-install-curt-20x60-carrier-2012-acura-mdx-c18100.aspx

Answer 1

Basically, in any state in the union, if the rear license plate or lights are obscured in any way, a police officer can pull you over, regardless of the specific verbiage of the laws. Beyond that it is just a good idea to add lights for safey. For…

view full answer...

Answer 2

Hey Brandy, yes you would be able to open the rear door of your 2020 Chevy Equinox with the Curt hitch cargo carrier part #C18152 installed and it would have clearance.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 8

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 9

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 10

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Your picture is of an old Tekonsha Weathertronic electric brake controller. The wire color coding is as follows: White - Ground Black - Positive terminal on the battery Blue - To the trailer brakes Red - Cold side of the stop light switch. This will…

view full answer...

Will the Pro Series Trailer Hitch Mounted Cargo Carrier Fit a 2008 Acura MDX

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching