Recommended Trailer Hitch for 2013 Volvo S60

Question

Question:

Hi The video on your site comparison say class II is the dose not stick from the back The Draw stick out

asked by: Talat

1

Helpful Expert Reply:

For your 2013 Volvo S60 I actually recommend just going with the Draw-Tite Class III 2" Trailer Hitch Receiver # 75916. This 2 inch hitch essentially has an identical mounting bracket design to the Curt 1-1/4" Hitch # C12066 you referenced, so it's not going to stick out any further. In fact based on installations we have performed with both hitches the Draw-Tite will likely be a bit more recessed behind the bumper than the smaller Curt model.

A 2" receiver is going to open up the door to a lot more accessories like bike racks and cargo carriers so this is your best option. There are adapters available to expand a 1-1/4 inch receiver to a 2 inch opening, such as with the Brophy # HTAD, but using these reduces the hitch's weight capacity by 50 percent and adds some instability to the connection so it's best to avoid using one if possible.

I have attached the written installation instructions for the Draw-Tite hitch that you can also take a look at.

expert reply by: Chris R

1

T

8/27/2019

Hi The video on your site comparison say class II is the dose not stick from the back The Draw stick out

Chris R.

8/27/2019

The Draw-Tite Class III Trailer Hitch # 75916 and the Curt Class II # C12066 are going to sit in the same place in relation to the rear bumper on your 2013 Volvo S60. In the video you mentioned we did call out the flush design of the Curt hitch in particular but this was because we had actually gotten the chance to install it on the S60. We have not had the chance to install the Draw-Tite # 75916 on this vehicle so we weren't able to physically demonstrate its position in relation to the bumper. Its mounting brackets and overall design through are almost identical to the Curt hitch so there isn't going to be a noticeable difference. The only change you will get is slightly less ground clearance with the Draw-Tite Class III simply because of the larger 2 inch receiver.

Answer 1

Curt offers a Class II hitch part #C12066 and a Class III #13266 for your 2018 Volvo V60. The big advantage the Class III (2 inch opening) has over the Class II is that more accessories are made for 2 inch hitches so you'll have an easier time…

view full answer...

Answer 2

We sure do Rob and congrats on the new SUV. To add a hitch to your 2026 Nissan Rogue, I recommend the etrailer item #e93ZR. This hitch is custom fit for your Rogue and comes with all hardware necessary for installation. The crosstube mounts entirely…

view full answer...

Answer 3

The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56386 and the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #HM11143735 are similar units from different manufacturers that are both…

view full answer...

Answer 4

The Draw-Tite #DT85MR and etrailer.com #e93ZR Class III hitches will be evenly matched in weight capacities for your 2021 Nissan Rogue, so we can disregard the capacities for this comparison. Especially since your Rogue can tow, when properly…

view full answer...

Answer 5

The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75916 will give you a hitch height of 14-1/4 inches from the ground to the inside top of the receiver. That means you will have a ground clearance of 11-3/4 inches at…

view full answer...

Answer 6

The Draw-Tite Handle Nut Assembly, part #1332 is a 1/2 inch nut that is welded to a handle. It does not include a bolt. I am including a link to a video that will show how the handle nut works. If you are needing the bolt and other hardware, you…

view full answer...

Answer 7

Take a look at the back side of your existing 7-way trailer connector. There should be a round plug connected to the back of the actual trailer connector. You should be able to slide out the gray catch on that connector then remove it. That round…

view full answer...

Answer 8

The Draw-Tite Max-Frame Trailer Hitch, part #75916 is a great fit for your V60. This is a Class lll hitch and it has a 2-inch receiver opening. The Kuat Sherpa 2.0 2-Bike Platform Rack will work with both vehicles. This rack has a weight capacity of…

view full answer...

Answer 9

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

view full answer...

Answer 10

For your 2015 Volvo XC70 I would recommend the Curt #13266 over the Draw-Tite #75916. These trailer hitches have an almost identical design. Although the Draw-Tite has a higher towing capacity, it looks like both of the hitches exceed the towing…

view full answer...

Recommended Trailer Hitch for 2013 Volvo S60

Products Featured in This Question

Continue Researching