Removing Roadmaster InvisiBrake System from Vehicle

Updated 08/13/2019 | Published 08/11/2019

Question:

I have a 2014 Ford Raptor and want to remove the InvisiBreak System and all the wires. Please let me know if you need additional info. Thx

asked by: Bruce B

Expert Reply:

When removing the Roadmaster InvisiBrake System # RM-8700 from your Ford Raptor you really just want to reverse the steps outlined in the attached installation guide. Taking out the 20 amp fuse for the power input is where you would want to start followed by disconnecting the two white plugs that are connected to the InvisiBrake module.

From there you will disconnect the air pressure and vacuum lines that are attached to the brake box. Unplug the breakaway switch wires that are plugged in as well. Then disconnect the cable and bracket form the brake arm so the air actuating cylinder can be taken out.

The vacuum lines will just reattach to factory specs after taking the plastic T-fitting and one way check valve from the system out.

If you have any other questions during this process please let me know and I will be happy to help further.

expert reply by: Chris R