Replacement Bearings and Seal for Freedom Axle 45264 Hub Assembly
Updated 08/12/2019 | Published 08/10/2019
Products Featured in This Question
Question:
I have a freedom axle 45264 hub, what bearings and seal do I need? I can’t find any numbers on the old bearings.
asked by: Jaime
Helpful Expert Reply:
Based on my research the 45264 model hub is designed for 3,500 pound axles and uses the # L68149 (1.378" inner diameter) inner bearing and # L44649 (1.063" inner diameter) outer bearing. The correct grease seal is # 168255TB, which has a 1.687" inner diameter.
It's also a good idea to go ahead and measure the inner diameter of your current bearings (or the diameter of the spindle where they sit) to verify these are a match.
Product Page this Question was Asked From
Replacement Trailer Hub Bearing - L68149
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- 1.38 Inch I.D.
- Bearing L68149
- Race L68111
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Q&A: Replacement Bearing Set for Freedom Axle 45264 3500 lb Idler Hub
- Shop: Double Lip Seal for 3,700-lb Marine Hubs
- Shop: Bearing Kit, 14125A/25580 Bearings, GS-2125DL Seal
- Shop: Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Q&A: Replacement Trailer Hub Bearings, Races and Grease Seal For Freedom Axle Hub 45264
- Article: Most Popular Wheel Bearings
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Disc Brakes for 2006 McClain (MCCL) Boat Trailer
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: Availability of USA Made Bearing Kit for 3,500 lb Trailer Axle
- Article: How to Bleed Your Trailer Surge Brakes
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Does Lippert 12" Electric Brake Assembly ABS Need To Be Programmed Or Paired For Setup?