Fit of JR Products 2-Stage Propane Regulator Cover

Question

Question:

Does this cover fit the MB Sturgis 108220 regulator?

asked by: Jonathan I

1

Helpful Expert Reply:

The # 37207-30295 cover you referenced will only fit a JR Products # 37207-30365 2-stage regulator. Both regulators are functionally identical but different in appearance.

expert reply by: Mike L

1

Answer 1

The only vertical 2-stage regulator cover we currently offer is the JR Products #37207-30295. This hasn't been tested with your regulator but they are typically all the same size so you could measure it to determine fitment. The larger 2nd-stage…

view full answer...

Answer 2

In order for a vertical and horizontal regulator to "breathe" and function properly, the vent opening must be pointed down. The writing on your Marshall 260 warns you about this at the bottom of of the etching. If your regulator is mounted…

view full answer...

Answer 3

Since this type of regulator is typically mounted to a copper propane line you wouldn't need to mount it, but yes, the four holes on the back of the MB Sturgis #108220 2-stage regulator will allow you to mount the regulator. The holes aren't…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

There are two different types of hitch available for your 2018 Subaru Forester. One type will be fully exposed once installed like the Curt #C13144 that you'd looked at, that would have the hitch crossbar visible from the rear and the other is…

view full answer...

Answer 12

Hey Phil, If you're looking for the factory wire harness for a plug and play connection you'll find a connector that's gray with a red/orange center like the plug on the Curt Custom Wiring Adapter for Trailer Brake Controllers #C51436.…

view full answer...

Fit of JR Products 2-Stage Propane Regulator Cover

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching