Solution for Lippert CouchStep that When New Module Was Installed Steps Work in Reverse

Question

Question:

Replaced module 164889 when connected the step operates in reverse . I inverted the motor wires and now it works but I cant get the stay out when Im at a campsite also how do you connect to purple wire to the magnetic door switch

asked by: Alan E

0

Expert Reply:

Sounds like you replaced the module on your RV steps with a newer style which uses the opposite door magnet/sensor setup and is why your steps now operate in reverse. The newer style magnets you need then are the part # LC301694 which I attached an install video for.

I attached a diagram that shows how the purple wire connects to the steps.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hey Allen! The Replacement Door Switch for Lippert Electric Coach Step #LC301694 is what you're looking for. How did your wires get cut?

view full answer...

Answer 2

If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…

view full answer...

Answer 3

The correct replacement motor for your Coach Steps is the Replacement Motor for Lippert Electric Coach Step part #LC301695.

view full answer...

Answer 4

The correct part may be the solution. The Replacement Control Module for Lippert Electric Coach Step #LC301702 you asked from is not a Kwikee Step controller. The Lippert Components Kwikee Control Unit for pre-IMGL/9510 Step Control with switches…

view full answer...

Answer 5

The original steps all came with the open switch originally so I would assume that it's the original configuration and that nothing has been previously replaced. If you just want to swap out the magnets, the opposite magnets that are normally…

view full answer...

Answer 6

The correct replacement control module for the obsolete Lippert Coach Step 128980 double retractable step kit is part #LC301702, according to the nice folks at Lippert. If you click the provided link, you can see a video product description of the…

view full answer...

Answer 7

The best option to replace your Lippert Kwikee 32 Series Electric Steps would be to use the Lippert Manual Pull-Out Step for RVs part #LC432682. This step is very similar to the Kwikee steps you have now but will mount a little differently which may…

view full answer...

Answer 8

The issue you described sounds like a faulty control module. In order to replace this you will want to use the Replacement Control Module for Lippert Electric Coach Step part #LC301702 which is a direct fit for your Lippert Steps 128980. I spoke with…

view full answer...

Answer 9

If there is something causing a short it is possible that the motor could be running too long after extending or retracting and that could cause the problems. When replacing the parts make sure gears and other moving parts are properly lubricated as…

view full answer...

Answer 10

We do have a wiring diagram for the Lippert Components Kwikee Step Rocker Switch #LC371010. I have attached a clip from the installation instructions that demonstrates how to wire this for you to check out.

view full answer...

Answer 11

The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…

view full answer...

Answer 12

I contacted the manufacturer and they confirmed that a replacement door switch for Lippert electric coach step is Item #LC301694. This item replaces the door switch that comes with single, double, or triple electric Lippert Coach Step or Stromberg…

view full answer...

Solution for Lippert CouchStep that When New Module Was Installed Steps Work in Reverse

Products Featured in This Question

Featured Help Information

Miscellaneous Media

Continue Researching