Replacement Control Module for Coach Steps Model 202-3207

Question

Question:

I have a 2002 37 ft gulfstream and i took the controller 202-3207 out as it is not working and can not find one .what is the replacement for it .thanks

asked by: Gary F

0

Expert Reply:

The replacement control module that you need for your 202-3207 control module on your Coach Steps is the Lippert part # LC301702 on our site. I reached out to my contact at Lippert who said this control module is the correct replacement for all of the Coach Steps no matter which model you have.

expert reply by: Jon G

0

Answer 1

Sounds like you replaced the module on your RV steps with a newer style which uses the opposite door magnet/sensor setup and is why your steps now operate in reverse. The newer style magnets you need then are the part #LC301694 which I attached an…

view full answer...

Answer 2

The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…

view full answer...

Answer 3

For a replacement motor on the Lippert Coach Steps for your Winnebago, you will need the Replacement Motor #LC301695. It will install underneath the base of your step with 3 bolts. The motor features a weatherproof plug and jacketing that goes over…

view full answer...

Answer 4

Based on my research the Lippert Kwikee 32 Series Electric Steps #LC372261 is the closest option we have available to your existing Coach model 725-0001 assembly. The mounting bracket does have an 8 inch x 22 inch bolt pattern and the steps…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 9

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Thanks for the information Kevin! To flat tow your 2025 Ford Bronco with a standard bumper and LED lights, I recommend the following parts: Tow Bar and Safety Chains - etrailer XHD Non-Binding Tow Bar for Roadmaster Direct-Connect item #e84ZR Base…

view full answer...

Replacement Control Module for Coach Steps Model 202-3207

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching