Can Paddle Boards be Transported with J-Style Carriers
Updated 07/02/2019 | Published 07/01/2019 >
Products Featured in This Question
Question:
Can two paddle boards be transported using two kayak “ J “ racks ? Four “ J’s” total
asked by: Ed
Expert Reply:
I do have a solution for you but J-Style carriers are meant to be used for carrying kayaks because paddle boards are supposed to be transported laying down flat.
The only way to have 2 J-Style kayak carriers and be able to transport your 2 paddle boards is with the Thule Compass Kayak and SUP Carrier w/ Tie-Downs # TH890000. For your application you need to lower the upright and stack your paddle boards on top of each other as you can't carry paddle boards using the J-Style setup.
If you would rather use a traditional paddle board carrier because of this then I recommend the Thule SUP Taxi XT Stand-Up Paddleboard Carrier # TH810001 which is also compatible with 2 boards.
I have attached review videos for each that you can check out.
Product Page this Question was Asked From
Thule Compass Kayak Roof Rack w/ Tie-Downs - J-Style - Folding - Clamp On
- Watersport Carriers
- Kayak
- Paddle Board
- Surfboard
- Roof Mount Carrier
- J-Style
- Post-Style
- Saddle-Style
- Folding
- Aero Bars
- Factory Bars
- Round Bars
- Square Bars
- Side Loading
- Clamp-On
- No Load Assist
- Thule
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Thule SUP Taxi XT Stand-Up Paddleboard Carrier - Roof Mount - 2 Boards
- Shop: Thule Compass Kayak Roof Rack w/ Tie-Downs - J-Style - Folding - Clamp On
- Video: etrailer Class III Trailer Hitch DIY Installation - 2022 Subaru Ascent
- Video: Installing the Curt Trailer Hitch Receiver on a 2024 Subaru Ascent
- Video: DIY Install: etrailer Trailer Hitch Receiver on your 2021 Subaru Ascent
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Malone Rack Pads for Crossbars - Stand-Up Paddleboards - 30" Long - Qty 2
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Landing Pad 27 for Yakima SkyLine And Control Towers - Qty 4
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Video: This Old Trailer : Replacing a 7-Pole Connector
- Q&A: Adapter to go From Yakima Skyline Tower to Jetstream Bar
- Q&A: Replacement Adapter for Yakima Jetstream Crossbar
- Video: Checking Out the Replacement Adapter and Seat for Yakima JetStream and HD Crossbars
- Video: Hands-On with the Replacement Adapter and Seat for Yakima CoreBar Crossbars
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Search Results: trailer tires and wheels
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Flat Tow Setup for a 2026 Ford Maverick
- Shop: Brake Controller



