Will the Timbren Axle-Less Trailer Suspension Systems Work With An I-Beam Trailer Frame

Question

Question:

How are the Timbren Axle-less suspensions I talked on an I-beam trailer?

asked by: Josh H

0

Expert Reply:

The Timbren Axle-Less Trailer Suspension System part # A35RS545E will work just fine on an i-beam trailer frame so long as you box in the side of the frame that the bracket for the system attaches to. This essentially means you will have to weld a steel plate on the i-beam frame where the bracket for the above system would install. If you are able to do this then you will have no issue with installation. This part of the process is also somewhat covered in the installation manual as well.

expert reply by: Conner L

0

Answer 1

An E6 error code on the Portable Power Watchdog Surge Protector #HU87FR would indicate that the Line 2 and neutral have been wired in reverse. This means that the outlet you're plugging into has these two wires flip flopped and the Watchdog is…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 9

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Will the Timbren Axle-Less Trailer Suspension Systems Work With An I-Beam Trailer Frame

Product Page this Question was Asked From

Continue Researching