Installation of Lippert Flexguard RV Slide-Out Kit Hardware
Updated 06/15/2020 | Published 06/19/2019
Question:
How does this attach at both ends? And where to attach as a blowen tire broke all the flex guard off at atboth ends. Thanks for input.
asked by: Ron C
Helpful Expert Reply:
I have attached photos of the installation instructions of the Lippert Components Single Flexguard RV Slide-Out Kit Hardware # LC1346271, and also sent you a link which has the install instructions you can check out. The instructions are as follows:
Installation
Note: Variations from the install, unless otherwise approved by LCI Engineering, will not be covered under
warranty.
1. Position Flex Guard under the slide-out room where the wiring or hoses to be protected are located.
2. Insert the aluminum pin (Fig. 1A) into the Flex Guard (Fig. 1B) with the mounting bracket (Fig. 1C)
facing up. Slide the star washer (Fig. 1D) over the end of the pin at the bottom of the Flex Guard and
push in place.
3. Slide the Flex Guard clips (Fig. 1E) onto the end of the Flex Guard with the holes in the clips facing the
direction of the hoses and wiring to hold them in place. Space all clips evenly throughout the length of
the Flex Guard.
4. Install Flex Guard mounting bracket (Fig. 1C) to the bottom of the unit floor, perpendicular to the
outrigger and furthest away from the I-beam or room bar, using four #10 x 1" self-tapping screws or
#10 x 1" wood screws (Fig. 2A).
5. Mount the flat end of the Flex Guard to the LCI-supplied mounting plate (Fig. 3A) mounted offset to
the aluminum pin (Fig. 1A) at the opposite end using two #10 x 1" self-tapping screws (Fig. 3B) per belt
section. Install the LCI-supplied mounting plate to the bottom side of the slide-out room.
6. Slide any hoses and wiring through the holes in the Flex Guard clips when installing in order to protect
hoses and wiring with the Flex Guard.
7. Flex Guard should be kept parallel to the slide room floor.
8. Make sure the flat end of the Flex Guard is mounted several inches away from the direction of the bend
of the retracted Flex Guard (Fig. 4).
Joe D.
6/11/2020
I bought a flexguard slideout kit to replace the one Actualy under my slideout on a Catalina 39 mkts. The rubberband is in good sape only the plastic brakets are broken. How do I get the cable through the plastic ring.
Product Page this Question was Asked From
Lippert Components Single Flexguard RV Slide-Out Kit Hardware
- RV Slide Out Parts
- Hardware
- Flexguard
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Lippert Components Single Flexguard RV Slide-Out Kit Hardware
- Shop: Lippert Double Flexguard RV Slide-Out Kit Hardware
- Q&A: Do the Lippert Flexguards Have a Different Width?
- Search Results: rv slide out parts
- Shop: Lippert Triple Flexguard RV Slide-Out Kit Hardware
- Search Results: flexguard rv slide out parts
- Shop: Replacement Gear Pack for Lippert RV Slide-outs w/ 2" x 2" Arm - No Roll Pin Assembly
- Video: Lippert Double Flexguard RV Slide-Out Kit Hardware Installation - 2007 Starcraft Homestead Lite Fift
- Shop: Dexter BrakeRite Electric Over Hydraulic Actuator for Disc Brakes - Vented - 1,500 psi
- Video: Breaking Down the Lippert Components Single Flexguard RV Slide-Out Kit Hardware
- Search Results: brake actuator
- Shop: Replacement Gear Pack for Lippert RV Slide-outs -2"x3" or 3"x3" Arms - Standard
- Shop: Tonneau Cover
- Video: Review of MORryde Replacement number 5 Rubber Shear Spring - MR85UR
- Q&A: What is the Length of the Strip Included with Lippert Single Flexguard RV Slide-Out Kit # LC1346271
- Shop: RV Interior Lighting
- Q&A: Determining The Correct Replacement Slide Out Motor For A 2007 Fleetwood Pace Arrow Motorhome
- Shop: Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles - 10" - 5 on 4-1/2 - Pre-Greased
- Search Results: dexter brake actuator
- Search Results: gears rv slide out parts
- Search Results: lift supports
- Search Results: gear pack rv slide out parts
- Video: Dexter BrakeRite Electric Over Hydraulic Actuator Manufacturer Interaction
- Video: All About the Opti-Brite RV Interior Strip Light w/ Switch
- Video: Lippert Slide-Out Gear Pack Installation - 2019 Grand Design Reflection Fifth Wheel
- Video: A Closer Look at the Opti-Brite LED Strip Light for RV Awnings
- Shop: RV Transfer Switch
- Shop: RV Electrical
- Shop: RV Power Cord
- Q&A: How to Get Wires Through The Lippert Double Flexguard RV Slide-Out Kits Brackets
on RV Slide Out Parts
Charles W.
1/26/2020
I have no oem supplied bracket to mount the flat end of the flexguard. Where can I purchase one?