Towing Setup Recommendation for a 2009 Mazda 3
Updated 01/31/2012 | Published 01/28/2012 >
Products Featured in This Question
Question:
I have a question about this hitch. Before I buy it I want to make sure that Im doing the right thing I have a 2009 Mazda 3 i and Im planing to rent a 4foot x 8foot trailer, I just want to make sure that I can install this hitch on my car and if that covers the requirements for using it with that trailer. Thank you very much, I appreciate your time.
asked by: Humberto R
Expert Reply:
This Draw-Tite Trailer Hitch Receiver # 24816 would be the correct hitch for your 2009 Mazda 3. I attached installation instructions and an installation video for this product for you to check out also. This hitch comes with a draw bar and a pin and clip.
This hitch has towing capacities of 2,000 lb gross trailer weight and 200 lbs tongue weight. You will need to make sure that the trailer you will be towing will weigh less than that. You will also need to check the towing capacity of your vehicle. This information should be listed in the owners manual of your vehicle. The rating of the lowest rated component in your setup will be your overall towing capacity.
To complete your towing setup you will need a few more products.
The first thing you will need is trailer wiring to activate taillights of the trailer you will be towing. For that you will want Tow Ready Custom Fit Vehicle Wiring # 118420. I attached installation instructions and an installation video for this product for you to check out also.
You will also need a hitch ball, most likely the coupler of your trailer will be either 1-7/8 inches in diameter or 2 inches in diameter. Because of that I recommend the Hitch Balls # 19256 and # 19258.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Installation Instructions for the Draw Tite Hitch # 24816
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Hadco 3077 Grease Seal Replacement Recommendation
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended Trailer Hitch Receiver For 2005 Mazda 3
- Q&A: Recommended Trailer Hitch Receiver for a 2007 MazdaSPEED 3
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will The Yakima Replacement 2 Inch Hitch Adapter, # Y8890174, Fit A Older Yakima 4 Bike Rack
- Q&A: Hitch and Wiring for 2009 Mazda 3 Hatchback Grand Touring




