Lift Kit for 2017 R-Pod Trailer Model 178

Question

Question:

Looking for axle riser fo Rpod 2017 model Rpod 178 model

asked by: Scott G

0

Expert Reply:

Since we know your R-Pod is newer than 2014 we know that your have the Lippert torsion style axles which means there are two different lift kits that will potentially fit. You will need to use the Axle Riser Kit part # LC382741 for square shaped axles or part # LC270682 for diamond shaped axles. If you look under your trailer at the axle it will be obvious which style of axle you have.

expert reply by: Jameson C

0

Answer 1

In nearly all situations trailer rims have a zero offset to balance the load of the trailer equally on both sides of the wheel. I can't see your RPod requiring an offset that isn't zero. I would recommend the part #LHAW121 for you though.…

view full answer...

Answer 2

Due to the orientation of your axle, I believe you have a Lippert Diamond Torsion Axle. If your axle label confirms this, you'll want to use the Lippert axle riser kit, part #LC270682 which provides a 3-1/2 inch lift and is our only diamond axle…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

Hey Dale, thanks for reaching out. For your 2010 Toyota Tundra with the factory tow package, a proportional controller is definitely the way to go for smooth braking on a 2-axle trailer, and a really clean option is the Redarc Tow-Pro Liberty…

view full answer...

Answer 8

Sure, I can help with that. I can see why the fitment notes are confusing. For a 2012 Toyota Tundra with the factory tow package and factory 7 way connector, you'll want a brake controller that plugs into the factory brake controller port under…

view full answer...

Answer 9

Hey Connor, since your 2007 Toyota Tundra comes with a factory 7-way the correct kit to install the Redarc Tow Pro Liberty would be the part #RED82CR which comes with the correct harness that plugs in under the dash of your truck. What are you…

view full answer...

Lift Kit for 2017 R-Pod Trailer Model 178

Continue Researching