What Angle Should Shackle Straps be on a Triple Axle Trailer with Double-Eye Leaf Springs
Updated 12/14/2011 | Published 12/13/2011
Question:
In a diagram that I printed earlier from you webb site, I see that you recommend placing load equalizers between all three axles. It appears that the shackles are tilted about 20 degrees. Is this a prescise measurement or just accomplished with eyeballing?
asked by: Ritchie
Expert Reply:
The angle of the shackle straps is not a precise measurement but you will want them to be around 45 degrees. The diagram may look different but staying around 45 degrees is where you will want to be. I have included a link to our FAQ article on double-eye trailer suspension for you.
Product Page this Question was Asked From
Triple-Axle Trailer Hanger Kit for Double-Eye Springs - 1-1/2" Front/Rear, 2-1/2" Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Triple Axle
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: lift block
- Search Results: spring hanger extension kit
- Search Results: leaf spring lift blocks
- Article: Double-Eye Trailer Suspension System Review
- Search Results: trailer lift blocks
- Q&A: Height From Skid Plate of Lippert 1621 5th Wheel Pin Box
- Shop: Trailair Air Ride 5th Wheel Pin Box - Lippert 1116 - 21,000 lbs
- Shop: MORryde Cushioned 5th Wheel Pin Box for 14K to 18K Trailers w/ Lippert 1116
- Shop: MORryde Rubber Equalizers for Triple Axle Trailers - 35" Wheelbase - 8K
- Q&A: Changing Spring Hangers To Raise Or Lower A Trailer
- Q&A: Are there Bolt-On Hangers for Trailer Leaf Spring Suspension
- Video: Correct Track Trailer Alignment and Lift Kit Review
- Video: Review of RV Ride Control Trailer Suspension Parts - Alignment and Lift Kits - RR23QX
- Shop: Suspension Enhancement
- Shop: Correct Track Trailer Alignment and Lift Kit - Single Axle
- Shop: Pacbrake Rear Block Kit - Custom Fit - Cast Iron - 2" Lift
- Shop: U-Bolt Plate - 2-3/8" Diameter, Round Trailer Axle - 2" Wide Spring - 1/2" Bolts
- Shop: MORryde X-Factor Crossmember Adapter Kit for OEM Correct Track Hangers
- Q&A: Effect of Installing Shorter Shackle Straps on Trailer with Axle Over-Under Kit
- Shop: Trailer Hitch
- Search Results: trailer hitch
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Search Results: trailer wiring
on Trailer Suspension Parts
