Replacement Ventline Range Hood Fan Blade and Motor Recommendation CC316-1

Question

Question:

The fan blade was gone off of this when we purchased it. What fan motor and blade do we need to replace it with. It is from a 1997 motor home. I am attaching pic of what we have . Thank you.

asked by: Charlie E

1

Helpful Expert Reply:

The replacement motor you need is the part # BVD0218-00-R for the Ventline Range Hood your RV has. The correct fan blade then is the part # BVD0216-00.

expert reply by: Jameson C

1

click to enlarge

Harlan S.

5/22/2020

My vent fan does not work (light does work). This is a systems monitor model CC316-1 in a 1995 Jayco Eagle Ford E350 motor home. Could this be a simple problem? Fuse? This worked when we stored the unit last fall. All other systems included in this monitor panel seem to be working. (Water heater, pump, etc.) Thank you for your attention to this question.

Chris R.

5/25/2020

You at least know that the circuit the vent is on is okay (since the other accessories - water heater, pump, etc - on that panel are working properly). So the wiring or power source itself likely isn't a problem. This does point to a problem with the motor. You could try ruling this out by making certain power is getting to the motor by actually testing the wiring just before it when turned on. If you're getting good power there, I do recommend replacing the motor itself with part # BVD0218-00. This should get the vent back up and running.

Harlan S.

5/25/2020

@ChrisR Thank you. I checked the fuses. All ok. Rechecked vent fan. It started working. Something must have been loose. Simple fix. Thanks.

Chris R.

5/28/2020

@HarlanS Awesome. Just let me know if anything pops up again.

Answer 1

The CC316-01 number you referred to is the original part number of the fan motor. Is it a replacement fan blade or motor you're needing? If that's the case, you'd use the #BVD0218-00-R replacement motor. If you were needing a replacement…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 10

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Replacement Ventline Range Hood Fan Blade and Motor Recommendation CC316-1

Products Featured in This Question

Continue Researching