What Does Key Look Like that Replacement BOLT Lock Cylinder # BL709231 Fits

Question

Question:

After adding the information for year and model Im shown a key that should fit. The key looks similar but if the key in the picture is actual size mine is a lot longer as is the barrel on the lock to my tailgate handle. And the tail on the end of the lock is crooked whereas the one on my truck is almost a 90 degree angle and Im not sure whether thats going to actually grab the lock when the key is turned or not

asked by: JAMES D

0

Expert Reply:

Thanks for the picture of the key you have! The Bolt Lock Cylinder part # BL692918 is a fit based on seeing that and knowing you have a 2002 Avalanche.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I can help you find the right replacement lock cylinder for your 2007 Chevy Avalanche LT Toolbox. If your current lock cylinder can be removed from your Avalanche's toolbox then you will need the Late Model GM Key Cylinder from BOLT #BL692915.…

view full answer...

Answer 2

A 2016 Chevy Colorado should have a center cut transponder key so you would need the Replacement Lock Cylinder for BOLT Toolbox Latch - Codes to Center Cut GM Key #BL7023480. This is just the replacement lock cylinder so if you're needing parts…

view full answer...

Answer 3

Hello Tyler, thanks for reaching out. We may have what you need, but I will need more information in order to know what locks will work. Does your ARE cap use the Bolt brand locks that key to your ignition key? If so, the Replacement Lock Cylinder…

view full answer...

Answer 4

Hey Justin! Based on the pin weight and GVWR of your 2020 Vanleigh Beacon 34RLB you will want to get the 4.5k TW model. There are two different models depending on your bolt pattern. If you have a Lippert 1621, 1621HD, 0719, or Fabex PB 600 Series…

view full answer...

Answer 5

It sounds like you have the New Body style of the 2007 Chevy Silverado. The picture you sent in is close to where you will need to install a 7-Way connector. If you check out the attached photo you can see where the round US Car Connector plugs in to…

view full answer...

Answer 6

Hello Mike, thanks for reaching out. The Replacement Shock for Dexter Model 6 and 10 Brake Actuators #T1242600 may work for you, but we do not carry the Gabriel brand, so the information available to me about their parts is limited. Basically, the…

view full answer...

Answer 7

Hey Jake, thanks for reaching out! You'll actually want to keep the OEM hitch on your 2005 GMC Sierra 2500 to install some TorkLift tie-downs as there aren't any TorkLift tie-downs that fit with the SuperHitch Original #TLC1204. For your OEM…

view full answer...

Answer 8

Based on previous information we have for your UFP HD-1377-10 hub it uses the following components. I do recommend pulling one of your hubs to verify that the replacements listed below match your current parts. Inner Bearing #L68149 (Inner diameter…

view full answer...

Answer 9

Hey George, welcome back! To get that high of a capacity out of an extension, you'll need the Gen-Y Hitch Receiver Hitch Extender item #GY89SR. This works with a 2" hitch receiver and extends the hitch pin hole out 14". It has a 10,000…

view full answer...

What Does Key Look Like that Replacement BOLT Lock Cylinder # BL709231 Fits

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching