Brake Installation Hardware and Torque Required for 10-Inch Drum Brakes
Updated 01/10/2019 | Published 01/09/2019
Products Featured in This Question
Question:
What size are the nuts and washers needed to hold the brake assembly to the axle plate?
asked by: David R
0
Expert Reply:
Electric drum brakes such as # AKEBRK-35L-SA will use nut/lock washer hardware kit # BRKH10BS and the nuts should be tightened to 45 to 50-ft-lbs. If you need a torque wrench we offer several such as # ALL644044 as well as Torque Adapter # PTM206 which fits any 1/2-inch ratchet.
expert reply by:
Adam R
0
click to enlarge
Product Page this Question was Asked From
Electric Trailer Brake Assembly - Self-Adjusting - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Self Adjust
- 10 x 2-1/4 Inch Drum
- etrailer
more information >
Continue Researching
- Q&A: Replacement Brake Assembly for Axletek 44-GG
- Article: Trailer Wiring Diagrams
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Q&A: Replacement Hub for a Lippert LCI 126003 Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: How to Know When Trailer Brake Magnets are Worn Out and Need Replacing
- Q&A: Can Velit Diesel RV Heater Heat 288 sq ft Snowmobile Trailer
- Q&A: How To Measure A Trailer Spindle To Find Replacement Hubs And Bearings
- Q&A: Initial Adjustment Of Self-Adjusting Electric Brakes On Trailer
- Q&A: Replacement Hub for AxleTek Hub # BD2-545-17
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Towing a Trailer? Let's Talk About Brake Controllers