Will Draw-Tite # 75237 Work on a 2016 Toyota Sienna SE

Question

Question:

Will this hitch fit an 2016 Toyota Sienna SE model as the rear bumper facia is possibly lower than a stock sienna? Thank you

asked by: Ben M

0

Expert Reply:

I spoke with my contact at Draw-Tite and he informed me that this Draw-Tite # 75237 should work on your 2016 Toyota Sienna SE. I asked about the lower trim piece that the SE models have on them and he informed that there will be an appearance panel that will need to be trimmed or removed in order for you to install the hitch but it will work for you.

expert reply by: Jameson C

0

Answer 1

The trailer hitch I recommend for your 2019 Toyota Sienna is the Draw-Tite Trailer Hitch #76112 because if you plan on towing, this hitch is rated for weight distribution and the similar hitches are not. When we test fit the Draw-Tite Hitch #76112,…

view full answer...

Answer 2

Hey Daniel thanks for all the questions! One of them is going to be pretty easy but also disappointing, every hitch for your 2019 Toyota Sienna is going to require the panel to be removed, trimmed, then reinstalled. This is actually not as hard to do…

view full answer...

Answer 3

There are a number of Class III trailer hitches designed to fit the 2018 Toyota Sienna. In my opinion you can break them up into two groups that distinguish the biggest difference: those with a visible cross tube and those with a concealed cross…

view full answer...

Answer 4

For your 2009 Toyota Sienna, I recommend the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13105 you referenced. From the lowest point of the hitch receiver you will have about 8-1/2 inches of ground clearance. The inside top of…

view full answer...

Answer 5

Hey Micah! Pacbrake has actually been around for a long time, more than 60 years. We have had customers ask for these air bags in the past, and we've seen them on vehicles coming in. Until now, Firestone has been the go to since their quality is…

view full answer...

Answer 6

There is not a minimum clearance required by law for a trailer hitch, so you simply want to make sure you are able to travel without bottoming out your receiver. For instance, the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C13105…

view full answer...

Answer 7

Hi Len! I had not noticed that before. I asked and Curt does indeed integrate the ground into the plug in connection on a lot of their wiring harnesses and the #C53VV T-Connector is one of them. Tekonsha almost always has a separate ground that needs…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

I can absolutely help with choosing a trailer hitch for your 2020 Toyota Sienna that will give you the best ground clearance. There are quite a few hitch options available for your vehicle, but the models that will sit highest off the ground when…

view full answer...

Will Draw-Tite # 75237 Work on a 2016 Toyota Sienna SE

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching