Is Sleeve-Lock A-Frame Trailer Coupler # CA-5196-B Designed for Weld On 50 Degree A-Frames
Published 11/28/2018
Question:
Is this a weld on for a 50 degree a frame trailer tongue assembly?
asked by: Robert P
0
Expert Reply:
Yes, the Sleeve-Lock A-Frame Trailer Coupler # CA-5196-B that you referenced is a weld-on coupler designed to fit 50 degree A-frame trailers like you mentioned. Nearly all A-frame trailers are 50 degree so it's hard to find A-frame couplers that are designed for a different angle.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Sleeve-Lock A-Frame Trailer Coupler - Flip Latch - Black - 2" Ball - 7,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- 50-Degree Frame
- Weld-On
- 7000 lbs GTW
- 2 Inch Ball Coupler
- Flip Latch
- 2-1/4 Inch Hole
- Standard Grade
- etrailer
more information >
Continue Researching
- Q&A: Is There a 4-Way Wiring Harness for a 2026 Chevy Equinox Activ?
- Q&A: Bearings and Grease Seal for Terran Axle Idler Hub
- Article: Trailer Wiring Diagrams
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Recommended Safety Chains for Curt Ball and Safety Chain Loops Kit # C60618
- Q&A: How to Select the Proper Length Safety Chains for a Trailer
- Q&A: Brake Controller Plug Location on 2021 Jeep Grand Cherokee
- Q&A: Replacement Mounting Bracket for DeeMaxx Disc Brake Caliper Hardware
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Thank you!
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Accurately Measure Trailer Leaf Springs