Mating Male Pipe for Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks
Published 08/15/2018 >
Products Featured in This Question
Question:
What is the correct part number for the MALE weld on swivel pipe mount that would fit inside this female brkt?
asked by: Pete K
0
Expert Reply:
The male part that mates with the Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks # TJP-OP916 is Replacement Male Pipe for etrailer and Ram Pipe Mount Swivel Jacks # TJP-IP916.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Replacement Female Pipe for etrailer and Ram Pipe Mount Swivel Jacks - 9/16" Pin Hole
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Q&A: Recommended Swivel Stabilizer Jacks w/ Bolt on Mounting Brackets
- Q&A: Replacement Bearings, Races, and Seals for Trailer
- Q&A: Replacement for Atwood 70079 Landing Gear Motor
- Q&A: Is There A 1.5" Hitch To 2" Hitch Adapter?
- Q&A: Wiring Diagram for 7-Way Round Pin Trailer and Vehicle Side Connectors
- Q&A: Wiring Diagram for a 1997 Peterbilt Semi Tractor with 7-Pin Round Connector
- Article: Hitch Mounted Cargo Carrier Information
- Article: How to Measure a Trailer Axle
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Where to Position the Trailer Axle?

