Proportional Brake Controller Recommendation for Replacing Draw Tite Activator

Question

Question:

I have a draw tite activator Installed in my motorhome I want to go to a proportional controller. Id prefer not to change the 4 wire connector on the controller. Is there a proportional controller that has the same pigtail connector.

asked by: Tom H

0

Expert Reply:

I have a perfect solution for you. Tekonsha brake controllers are made by the same brand as Draw Tite so the connectors are the same. So you could install a proportional P2 part # 90885 and you'd be set. This plugs right into the same connector as your Draw Tite so it's a great option. This is the most advanced proportional controller too

expert reply by: Jameson C

0

Answer 1

We have an option for you. The Draw-Tite Activator IV #5504 is an exact replacement for your now discontinued Draw-Tite Activator II. It has the same function but with a little bit of a visual difference. Instead of a dial like on your Activator II…

view full answer...

Answer 2

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 3

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Proportional Brake Controller Recommendation for Replacing Draw Tite Activator

Continue Researching