Replacement Charger for Solera 18 Volt Power Awning

Question

Question:

Can you supply the b18 holt charger for this unit? I lost mine. Its 388619 18 volt battery charger

asked by: Mark H

0

Expert Reply:

For your Solera Universal Awning Support Arms for RVs - 18 Volt Power - 69" Arms - Black # LC434729 we do have the replacement charging cable available. It is part # LC388169. I confirmed this fit with my contact at Solera.

expert reply by: Jason S

0

Answer 1

I spoke with someone from Lippert and I was told that you need to let the power arms charge for a full 24 hours. They also sent me trouble shooting steps, which I have included below. From Lippert If your battery is not charging properly: 1. If you…

view full answer...

Answer 2

Hey Dave, the battery is supposed to be good for 20-25 retractions before needing charged. If yours won't hold a charge it does sound like it needs to be replaced which we have with the part #LC387959.

view full answer...

Answer 3

Thank you for your purchase of the Aluminum Viking Series Valhalla Trailer Wheel #AX02665865HDBML! The most common lug nut size for trailer tires is 1/2" so you should be able to use the Stainless Steel Lionshead Trailer Wheel Lug Nut -…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Replacement Charger for Solera 18 Volt Power Awning

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching