Locating Brake Light Switch on 2005 International 8600 Truck
Updated 06/22/2018 | Published 06/21/2018
Question:
Need to know where is the brake light switch on a 8600 05 International
asked by: Elton
Expert Reply:
If your 2005 International 8600 has hydraulic brakes, then the brake light switch should be located somewhere right above the brake pedal. I was unable to locate what color this wire might be, so you will simply need to test the factory wires with a circuit tester like # PTW2993. You are looking for the wire that only receives power with the brake pedal depressed, and no power with any other function.
Once found, this is the wire that will connect to the red wire on the Tekonsha Prodigy P3 Brake Controller # 90195 that you were looking at.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - Up to 2 Axles - Proportional
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How Does Brake Controller Install in Tiffin Phaeton 40AH
- Q&A: Comparing Aluma-Tow Adjustable Ball Mount To B&W, etrailer, and Trimax
- Q&A: Recommended Trailer Wiring and Brake Controller for a 1999 Dodge Ram 2500
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Can Redarc Tow Pro Liberty Brake Controller Install 2012 Toyota Sienna LE
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: How To Tell Apart 5,200 lb, 6,000 lb and 7,000 Axles
- Q&A: How To Turn Off The Tekonsha Prodigy P3 Brake Controller # 90195
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: 5 Things to Know About Weight Distribution Hitches