Replacement Wire Rope Recommendation for Superwinch LT2000

Question

Question:

Good Morning what is the correct part number for a replacement winch wire rope for a Super Winch LT-2000? is there a Synthetic Rope available for this model? Thanks,

asked by: Rick S

0

Expert Reply:

The Superwinch LT2000 winch has a 50 foot long wire rope with a 5/32 inch diameter so for a replacement the best I can currently offer is the # FWC7500100 which is 7/32 and 50 foot and you'd be set. There's no way to convert the winch to a synthetic rope.

I attached a picture that covers how the replacement is done as well.

expert reply by: Jameson C

0

click to enlarge

Answer 1

If you're going to use a winch to raise and lower your popup you will want a winch that power loads both in and out. With a winch that will only power load in you will only be able to raise the popup and not lower with the winch. We have the…

view full answer...

Answer 2

When installing the Superwinch LT2000 ATV Winch #1120210 on atv's or offroad vehicles, the red wire on the rocker switch typically connects to a wire that gets power only when the ignition switch is turned on. When using this winch on a trailer…

view full answer...

Answer 3

You will need a 12 volt battery that is rated for more than 55 amps to power your electric winch. Any battery that meets those requirements should work well for you. For most winches that usually means a car battery. I have included a link to the…

view full answer...

Answer 4

For the Superwinch LT2000 ATV Winch #1120210 we currently sell that winch kitted with the upgraded switch kit. This switch kit would attach to the handle bars on your ATV that you were using the winch on. If you are talking about the hand held remote…

view full answer...

Answer 5

To operate a DC powered winch such as #1120210 that is not installed on a vehicle you will need a 12 volt battery with a high enough amp hour rating for the draw of the winch under load. Superwinch LT2000 Electric Utility Winch #1120210 draws 100…

view full answer...

Answer 6

If the Superwinch LT2000 ATV Winch part #1120210 that you have attached to your pop up camper is bending the original brackets that your pop up was equipped with I recommend taking it to a local welding shop and having new and additional bracing…

view full answer...

Answer 7

We have 12 volt winches like the Superwinch LT2000 part #1120210 that would work well for what you need as this has a 2,000 lb capacity but we do not carry the specific winch you are looking for.

view full answer...

Answer 8

The dynamic brake on the Superwinch LT2000 winch #1120210 is not meant to hold a load indefinitely so it would not really be the best option for you. I recommend a winch that has mechanical braking. Or you could use a worm gear winch which has a…

view full answer...

Answer 9

Winches are not designed to hold a load for extended periods of time. Once you have the load lifted into position you would need to use chains or rope to then support the load. Bulldog Winch #BDW10041 is more than capable of hoisting a 3,000 pound…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Wire Rope Recommendation for Superwinch LT2000

Continue Researching