Replacement Baggage Door Latch for 2005 Fleetwood Discovery

Question

Question:

will this match fleetwood 05 discovery part #10089649

asked by: Richard F

0

Expert Reply:

Based on my research, it looks like the 10089649 lock on your Fleetwood Discovery RV features an outer housing that measures 4-1/2 inches x 5 inches, which does match the dimensions for the Lippert Components Baggage Door Latch Kit # LC317649 that you referenced.

I have attached couple images with some additional measurements labeled so you can compare them to your existing latch to see if this will work nicely as a replacement.

expert reply by: Chris R

0

click to enlarge

Answer 1

Thank you for reaching out! What is the weight rating of your axle? Unless it's a really old axle I should be able to make a recommendation based off of that. The Dexter Axle part number you sent in normally doesn't pull anything up on their…

view full answer...

Answer 2

The lifespan of Atwood carbon monoxide and LP sensors like the part #AT36681 that you referenced is 7 years so if you are having alarms go off at 2-1/2 years I'd recommend taking the alarms seriously. You can also make sure the batteries that it…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 6

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 7

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Replacement Baggage Door Latch for 2005 Fleetwood Discovery

Product Page this Question was Asked From

Continue Researching