Are Global Link Keys like part # 391 Generic Keys

Question

Question:

Is Global link key 391 a generic key, like 751, or a new series of keys? I looked at other sites but all sites state that Global link keys only are available G301 to G390? Confused? Thank you

asked by: Kimoe

0

Expert Reply:

Global Link makes several different key numbers like the part # 295-000079 which is key number 391, and part # 295-000060 which is key number 334 etc. These are generic keys that all open locks universally.

Are you looking for a specific key number?

expert reply by: Jameson C

0

Answer 1

Thank you for the picture, it is super helpful. We do have the keys that you need. For your CH751 key you will need the Valterra 751 Replacement Keys for RV Hatch Doors #A524VP which comes with 2 keys. For your G391 key you will need the Key for…

view full answer...

Answer 2

The difference between the letters D and R on a trailer tire size is to show the different tire's construction. D stands for bias ply and R for radial. The main difference between a radial ply and a bias ply tire is how the tire is constructed.…

view full answer...

Answer 3

Sounds like you have a Global Links door latch based on what you have mentioned and the correct replacement G391 key would be the part #295-000079.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Are Global Link Keys like part # 391 Generic Keys

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching