Is Passive Inlet Vent Needed With Ventline Powered Vent in Camper Shell?
Published 02/06/2018
Products Featured in This Question
Question:
folks, if I get the 12 vdc 6.25 inch powered circular vent.. should I install a passive inlet vent as well to insure best condensation venting in an aluminum skinned camper shell? In your estimation would a neoprene foam spacer provide sufficient strength to mount the vents to the shell roof?
asked by: Anthony H
Expert Reply:
When installing the Ventline Vanair Trailer Roof Vent # VP-543SP a passive inlet vent such as # HMAV2-AVT2 certainly would not hurt though it is likely not necessary, though it would be difficult to say for sure without knowing the rest of your ventilation, the size of the camper and how much condensation you are likely to produce.
In regards to your question about the spacer, you are correct that a spacer will be needed for the thin camper shell.
I've added links to video reviews of these parts for you to take a look at.
Product Page this Question was Asked From
Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Manual Lift
- 12V Fan
- Plastic
- Tinted
- Ventline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: 12v light
- Search Results: 12v wire
- Search Results: trailer wall vent
- Search Results: x track
- Search Results: floor vent
- Search Results: e track motorcycle
- Search Results: x track rail
- Shop: CargoSmart Motorcycle Wheel Chock for E Track or X Track Systems - 7" Wide Tires
- Shop: Snap-Top Battery Box with Strap for Group 24 to Group 31 Batteries - Vented
- Shop: MaxxFan Deluxe Roof Vent w/ 12V Fan, Thermostat, and Remote - Powered Lift - 10 Speed - Smoke
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: etrailer Electric Trailer Jack - Drop Leg - A-Frame - 22-1/2" Lift - 3,500 lbs
- Video: CargoSmart Motorcycle Wheel Chock for E Track or X Track Systems Spec Review
- Video: Comprehensive Review: Stabilizer Jacks
- Video: Comprehensive Review: etrailer E Track
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Video: Review of Attwood Battery Boxes - PowerGuard Pro Vented Battery Box 24 27 31 Group - AT69RR
- Video: How to Install the MaxxFan Deluxe Roof Vent with 12V Fan - 2025 Keystone Cougar Half-Ton Travel Trai
- Q&A: Installing Vent in 6x12 Enclosed Cargo Trailer To Keep Interior Cool When in Storage
- Shop: RV Electrical
- Shop: RV Power Cord
- Shop: Rambler ST205/75R15 Trailer Tire with Black Vesper Mod Wheel - 5 on 4-1/2
- Shop: Roof Vent Installation Kit - Sealant, Butyl Tape, Screws - White
- Q&A: Are Backing Plates Required To Install Erickson E-Track System
- Shop: Blind Spot Detection
- Video: Detailed Breakdown of the Ventline Vanair Trailer Roof Vent w/ 12V Fan
- Q&A: How Tall is the Exterior Portion of the Ventline Vanair 12-Volt Trailer Roof Vent # VP-543SP
- Q&A: Can the Ventline Vanair Trailer Roof Vent be Used on a Truck Bed Camper Shell
- Q&A: Replacement Motor and Diagram for Ventline Vanair Trailer Roof Vent
- Q&A: What Is Install Kit of Furrion Chill Low-Profile RV AC with Heat Pump
on RV Vents and Fans
