Recommended Rail to Attach Awning or Slide Out Topper to Camper or RV

Question

Question:

Description says rails are included but comments say no rails do the rails come with rails?

asked by: Marvin A

0

Expert Reply:

The Solera 10.5' Slider (Slide-Topper) in Black w/ Black Hardware # LCV000182037 comes with the awning roll bar rail and also the rail extrusion that attaches to the RV.

expert reply by: Jason S

0

Answer 1

For determining the proper size Solera Slider you need, measure the total width of your slide room from the outside including the flange then add about 5" (2-1/2" each for the left/right side overhang). You can have greater than 2-1/2"…

view full answer...

Answer 2

I have linked the photo I believe you are speaking of. The bracket on the Solera RV Slide-Out Awning part #LCV000182037 is right at 2" which should allow you to mount it in the space you have. We have always used the supplied fasteners which are…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 6

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 7

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Kenneth, yes we do have exactly what you are looking for with the part #SO45FR. This is the replacement Solera 3000 Series awning arms and hardware in the black color. How did you damage yours?

view full answer...

Answer 10

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 11

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 12

Hey David, welcome back! Sorry to hear about your awning getting ripped off. That's a real bummer. The two part numbers are what you need and do come with everything you see pictured. For the awning the part #SO45FR would be the correct kit and…

view full answer...

Recommended Rail to Attach Awning or Slide Out Topper to Camper or RV

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching