Maximum Inlet Pressure for Valterra Water Regulator # A01-1120VP

Question

Question:

is there a MAX pressure this can handle?

asked by: Derek

0

Expert Reply:

I spoke with my contact at Valterra regarding the Water Regulator # A01-1120VP referenced in your question. She stated that the maximum inlet pressure for this regulator is 150 psi.

I have attached a short video demonstration on this product that you can also check out.

expert reply by: Chris R

0

Answer 1

Hey Jon, Most trailer wheel and tire combos - like the Kenda Karrier #KE69JV - do not come pre-balanced. Typically, trailer owners don’t worry about balancing since trailers don’t ride as smoothly as passenger vehicles and you’re not feeling that…

view full answer...

Answer 2

Hey Michael. The Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire with 15" Silver Mod Wheel - 5 on 4-3/4 item #KE42EV has a speed rating of N. This means it can go up to 87 mph. What kind of trailer do you have?

view full answer...

Answer 3

We did have one person a few years ago let us know that their #A01-1120VP did fail at 6 months but we've sold quite a few of these without any similar problems. There isn't any way to test these before installing to determine if they are…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Maximum Inlet Pressure for Valterra Water Regulator # A01-1120VP

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching