Distance Between Mounting Holes of Carr Custom-Fit Side Step # CARR103991
Published 12/05/2017
Question:
What is the distance between holes that secures step to vehicle?
asked by: Guy K
0
Expert Reply:
The distance between the two mounting holes on the mounting bracket for the part # CARR103991-1 is 1.9 inches.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Carr Custom-Fit Side Step - Hoop II - Black Powder Coated Aluminum - 7" Step - Qty 1
- Nerf Bars - Running Boards
- Side Steps
- 3-1/2 Inch Wide
- Matte Finish
- Fixed Step
- Aluminum
- Black
- Carr
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Need To Replace Dometic Awning MFR 916FT.21 501UL PNC 958603680
- Q&A: Is there Any Steps for My 1976 Chevrolet K5 Blazer that do Not Require Drilling to Install?
- Q&A: What Is A Good Adapter To Go From My 2 1/2 Hitch To A 2 Inch?
- Q&A: Where To Find The Factory Brake Controller Wire Harness In A 2023 Ford F-150
- Q&A: Comparing Hollywood Racks Sport Rider SE and RV Rider Bike Rack
- Q&A: Will the RockyMounts Backstage fit Electric Bikes with Fenders?
- Q&A: 1998 Ford E-350 Cargo Van Floor Mat Recommendation
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Rooftop Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Brake Controller Installation: Starting from Scratch