How Tightly Should a Trailer Hub Castle Nut Be Torqued When Installed

Updated 11/13/2017 | Published 11/11/2017

Question:

what is the procedure for torquing a crown nut ? I know how to do a double nut and a pro torque but if never had to do a crown nut

asked by: Juan M

Expert Reply:

The castle nut on a trailer spindle should not be torqued down tight. This could cause excess pressure on the bearings that could result in heat-related damage to the bearings or spindle. The best way to go is to tighten the castle nut until it stops; then back it offer about a quarter-turn before securing it with the tang washer. Please refer to the linked video at the 2:15-minute mark.

expert reply by: Adam R