How to Install the etrailer Electric Trailer Brakes on a 2009 Carriage Cameo Fifth Wheel Video

Hey Byron, good to hear from you again! The 16" Aluminum Jaguar Trailer Wheel #274-000011 weighs in at 17-1/2 lbs.

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

The left side is the driver side, right side is passenger side. On a trailer brake assembly like #23-105 the arm that the magnet is on points to the front of the trailer and the magnet always will be on the bottom. I have included a picture that…

One wheel locking up on your trailers brakes could be for a few reasons. The most likely reason is be due to a brake assembly that is out of adjustment. You want to adjust the assemblies so there is only a light drag on them when they are turned by…

The easiest way to temporarily disconnect power to the trailer brakes is to disconnect your brake controller. Unplug the brake controller plug from the back of the brake controller. The trailer brakes cannot draw power from the vehicle's battery…

The torque spec for the bolt part #7-103 is 106 ft lbs.

The Aluminum Jaguar Wheel #274-000011 does not have a PSI rating, but it's included valve stem does and is rated to 80 PSI. If the tire you're installing requires more air pressure then that, you'll just need to replace the included valve…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

This is a great question. You generally want to allow 3" clearance between the top of the tire and the fender (or bunk), at minimum, when your trailer is fully loaded. This should give you adequate clearance for potholes and bumps. In order to…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point Calibration The…