How to Pick Out Correct Rise/Drop Ball Mount for Cadillac SRX When Towing
Published 11/06/2017
Question:
I just installed one of your hitches and wire harness on my 2016 Cadillac SRX. The hitch is at 18inch from ground to center of receiver opening. What is the recommended height ball mount part number? for a 2inch ball?
asked by: Steve M
Expert Reply:
That depends on the coupler height of your trailer when sitting level. You'd need to measure from the bottom lip of your coupler down to the ground when the trailer is level. Whatever the difference is between that number and the height from the ground to the top of hitch opening on your vehicle is the amount of rise/drop that you need.
I attached a help article that covers this as well down below.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Q&A: Will Addition of Trailer Hitch and Transmission Cooler Allow 2015 Cadillac SRX to Tow 2,900 LB Boat
- Article: Anti-Rattle Devices
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Q&A: Best RV Rated Cargo Carrier Option for Cooler, Generator and Bikes
- Q&A: Recommended Hitch and Cargo Carrier for a 2021 Ford Bronco Sport
- Q&A: What Is the Difference Between the Curt Cargo Carrier 18150 & 18152?
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Best RV Roof Vents