What Size Hole is Needed to Install the LED Trailer Clearance/Side Marker Light
Published 11/03/2017
Products Featured in This Question
Question:
What diameter hole does it require to mount the 2inch clearance light with the rubber grommet?
asked by: Cody B
0
Expert Reply:
In order to install the LED Trailer Clearance/Side Marker Light part # MCL55AB you will need the Flush Mount 2" Round Grommet part # A54GB and the Right Angle 2-Wire Pigtail for Optronics Trailer Lights part # A46PB. Once you have acquired these items the rubber grommet will require a 2-5/16" diameter mounting hole to install.
I have attached an installation video of the rubber grommet for you as well.
expert reply by:
Conner L
0
Product Page this Question was Asked From
Optronics LED Trailer Clearance or Side Marker Light - Submersible - 3 Diodes - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Review of Dexter Grease Cap Plug EZ Lube Grease Caps - DX89HR
- Search Results: grote tail light
- Search Results: trailer lights
- Search Results: trailer hitch
- Search Results: brake actuator
- Search Results: trailer jack
- Search Results: lug nut torque
- Shop: TowTether Breakaway Trailer Safety Cable - Stainless Steel - Qty 1
- Shop: Rubber Grommet for 4" Round Trailer Lights - PVC
- Shop: Dexstar Steel Spoke Trailer Wheel - 16" x 6" Rim - 8 on 6-1/2 - White Powder Coat
- Search Results: trailer tires and wheels
- Shop: Stabilizer Jacks - 6-1/4" Drop Leg Travel - 18" - 650 lbs - Qty 2
- Shop: Peterson LumenX LED Trailer Light - Brake, Tail, Turn - Weatherproof - 12V/24V - Oval - Red
- Shop: Replacement Male Pipe for Curt Pipe Mount Swivel Jacks - 2"
- Shop: Replacement Male Pipe for Curt Pipe Mount Swivel Jacks - 2"
- Shop: Trailer Wiring
- Video: A Closer Look at the Stabilizer Jack
- Video: Stabilizer Jacks Review
- Video: Stabilizer Jack: The Breakdown
- Video: Optronics Trailer Lights A91BOB Review
- Video: Optronics Sealed Thin Line Two-Bulb Trailer Clearance Light Installation
- Video: All You Need to Know About the 2" Round Grommet
- Q&A: Availability of Trailer Taillight ID Bar that Has LEDs
- Q&A: Does Optronics Mini Thin Line LED Marker/Clearance Light # AL191AB Use Grommet # A91GB
- Q&A: Availability Of White Replacement Fender For 2003 Shoreland'r Trailer W/ ST205/75R15 Tires
- Q&A: Flush Mount Grommet and Wiring Pigtail for 2 Inch Clearance and Side Marker Lights
- Q&A: Does The Optronics LED Side Marker Light # AL91AB have 2 Male Connector Posts
- Q&A: How Does Part A91BOB Mount To The Trailer and Are The Lights It Holds Submersible
- Q&A: Optronics Trailer Clearance Light Similar to AL 91RB that Installs With Smaller Hole Drilled