Can Torklift PowerArmor Battery Box TLA7710R Mount on A-Frame Trailer

Question

Question:

Heavy duty enough to mount on the A frame without angle iron braces?

asked by: Mike

0

Expert Reply:

Yes, the TorkLift PowerArmor Locking Battery Box # TLA7710R is sturdy enough to mount on an A-frame trailer without using extensive bracing.

I attached a picture of someone who did something similar.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The TorkLift PowerArmor Locking Battery Box - 6V and 12V Batteries - Diamond Plate Aluminum #TLA7710R weighs 36 lbs.

view full answer...

Answer 2

Good question, so I reached out to Goal Zero, and they said that you would need a solar controller along with the adapter to connect the Solar on the Side with your Goal Zero Nomad 100 Solar Panel #287-13007: - Spade to SAE Cable for Goal Zero 10 Amp…

view full answer...

Answer 3

For the Progressive Dynamics converter #PD64FR that you referenced on the DC side you would need to use the 2 or 0 gauge wire otherwise you would most likely see an error code.

view full answer...

Answer 4

Hey Dale, we really have to stick with recommending mounting the Progressive Dynamics Transfer Switch part #PD64FR in the ways that you mentioned which are outlined in the instructions. They do recommend putting a shield over the fans if you want to…

view full answer...

Answer 5

To calculate power consumption simply multiply wattage by the number of hours it is being used. Remember to consider type of current, AC or DC. The number of watts is equal to amps multiplied by volts. Your battery bank is rated in Amp Hours, AH. If…

view full answer...

Answer 6

The Torklift #TLA7710R battery box is intended to mount to the trailer frame via the included self-tapping screws that you'd shoot through the box and into the trailer A-frame. You could use U-bolts if you wish but it isn't necessary.…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Can Torklift PowerArmor Battery Box TLA7710R Mount on A-Frame Trailer

Product Page this Question was Asked From

Continue Researching