Measurement From Tube to Front of Head on eTrailer Electric Jack EJ-3520-BBX
Published 10/04/2017
Question:
I bought a extended receiver for my truck so the tailgate will lay down flat with the manual crank tongue jack. What is the distance from the front of the tube to the front of the power head? I need to have the tailgate lay flat while the camper is still connected to the truck.
asked by: David S
Helpful Expert Reply:
I went to the warehouse to take a measurement of the eTrailer Electric Jack # EJ-3520-BBX and found that the measurement from the the tube to the front of the head unit was roughly 5-1/4".
I've added a link to a video review of this jack for you to take a look at as well.
Product Page this Question was Asked From
Electric Jack w/ Footplate - A-Frame - 25-1/8" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 18 Inch Lift
- Bolt-On
- 1 Jack
- RAM
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: The Best Electric Trailer Jacks of 2025
- Q&A: Availability of Wiring Diagram for the Replacement Power Switch # EJ-3520-PSW
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Electric Trailer Jack For A 2018 Jayco Whitehawk
- Q&A: Looking For Electric Jack That Can Be Rotated 90 Degrees
- Q&A: Wiring An Electric Trailer Tongue Jack Into 7-Way Vehicle Trailer Connector
- Q&A: What is Height of etrailer Electric Jack Above Mounting Bracket
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Is There Trailer Jack that Has Best Tailgate Clearance
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: How to Install an Electric Trailer Jack