Replacement Drive-In Studs for Hub with 6 on 5-1/2 Inch Bolt Pattern

Published 09/29/2017

Products Featured in This Question

Trailer Hub Wheel Stud - Drive In - 1/2" Diameter x 2" Long - Qty 1

(110)

$10.22

Replacement Trailer Hub Wheel Stud, Drive-In, 1/2" x 2-3/4" - Qty 4

(135)

$9.99

Question:

Hi, I have a BD-655 drum hub for a 6 on 5 1/2 wheel. I need to replace 3 of the studs and Im a little unclear on which stud will work. Im looking at the Redline 1/2inch stud item # 7-122. Could you either confirm that this is correct or point me in the right direction? Thanks,

asked by: Nick F

Expert Reply:

I was not able to track down specific information regarding the studs for your existing hubs, but if you have a 5,200 to 6,000 pound hub with the 6 on 5-1/2 inch bolt pattern you mentioned, you will likely need a 1/2 inch drive-in stud.

If your existing studs are 2 inches long, then the Redline Trailer Hub Wheel Stud # 7-122 referenced in your question will work perfectly as a replacement. For 2-3/4 inch long drive-in studs, you will need the Redline # RG03-080.

If you find you have a different length, I have also attached a link that will take you to our available selection of 1/2 inch diameter drive-in studs that you can look through.

expert reply by: Chris R